Verilink WANsuite 5330 (34-00302.F) Product Manual Manuel d'utilisateur télécharger pdf (Page 42)

3-14 WANsuite 5330

Service Details Screen

Clicking on an index number under the “Service Index” column on the

Services screen will display a Service Details screen (Figure 3.10) such as the

one shown below. (In this example, the selected service type is Frame Relay.)

Figure 3.10

Service Details Screen

The Service Details screen lets you change the following parameters for each

Any changes made to a service require a “Save and Restart” to take effect.

* PPP is the only service that may be attached to the Virtual interface. You would choose the

Virtual interface for PPP if you elected to run PPP over Frame Relay. When you attach PPP to

the Virtual interface, you must supply an endpoint over which to send PPP encapsulated data,

and that endpoint must be for a Frame Relay DLCI.

In addition, the Service Details screen provides the following user-activated

buttons:

Parameter Options

Interface Supervisory, Network, Serial, 10/100 Ethernet, Virtual*

Type TDM, PPP, Frame Relay, IP, tty, SCADA

Pair User-assigned integer field that specifies where to route the traffic from

this service. If the service is terminated by the unit, set this value to “0”

(zero).

Button Function

Submit Sets any values that have been changed.

Interface Details Opens the Details screen for the Interface of the currently selected

service.

Type Details Opens the Details screen for the Type of the currently selected

service.

Delete Service Opens the Verify Delete Service screen.

Refresh Refreshes data on the current page.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 134 135

Pas de commentaire

Verilink WANsuite 5330 (34-00302.F) Product Manual Manuel d'utilisateur Page 42