Verilink WANsuite 5330 (34-00302.F) Product Manual Manuel d'utilisateur télécharger pdf (Page 22)

1-8 WANsuite 5330

Serial Interface

The SERIAL interface located on the rear of the WANsuite 5330 is a multi-

protocol interface presented physically as a DB-25 connection. The protocols

supported by this interface are RS-232, EIA-530, and V.35.

Cables that adapt the DB-25 interface to the 34-pin V.35 interface are

available. These cables are optional equipment and their part numbers are

listed under Optional Equipment on page A-4. DB-25 to DB-25 cables are

also available if your installation needs require them. See Ordering

Information on page A-4 for details. Pin assignments for the Serial interface

are listed in Appendix A, Specifications.

CAUTION: FCC rules require that interconnecting cables carrying high-speed

data be shielded appropriately to minimize radio frequency

interference.

Network Interface

Labeled on the rear panel of the WANsuite 5330 as NET, the Network

interface connection is a standard RJ-48C, eight-pin modular jack that

contains an automatic line build out (ALBO) allowing the unit to be located a

substantial distance away from the telco network interface with a receive

signal level to −49 dB. The Network LBO level cannot be set by the user. To

view the pinout assignments for this interface, refer to Network Interface Pin

Assignments on page A-7.

CAUTION: In accordance with FCC Rules, Part 68.218(b), you must notify the

telephone company prior to disconnecting this product.

Power Connection

The POWER port is an eight-pin circular mini-DIN connector that connects

the autoranging 100–240 VAC external power supply to the unit. The

WANsuite 5330 is intended to be used with a UL Listed/CSA Certified Class

2 power supply with a minimum output rating of 4.0 A at +5 VDC. The unit

has no power switch.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 134 135

Pas de commentaire

Verilink WANsuite 5330 (34-00302.F) Product Manual Manuel d'utilisateur Page 22