Verilink WANsuite 5330 (34-00302.F) Product Manual Manuel d'utilisateur télécharger pdf (Page 118)

4-40 WANsuite 5330

Figure 4.30

Network Test Details Screen

BERT Table

The BERT table lets you set the following test parameters:

Setting

Displays the bandwidth on which you wish to perform the BERT. The

available values for this parameter depend on which interface is selected, so

for the network interface would be Net.

BERT Pattern

Specifies the pattern to be transmitted during a test for the selected port.

Values: Marks, QRSS, 511, 2047, ITU 2

, Spaces

Default: 511

NOTICE: The 2

pattern is the ITU (European) version, not the ANSI version.

Test Duration

Specifies the length of time for which the test should run for the selected port.

Values: 15 minutes, 30 minutes, 1 hour, 24 hour, Continuous

Default: 15 minutes

The BERT Table screen also displays the following read-only parameters:

Pattern Sync

Displays the state of pattern sync during a test. If no test is in progress, “No

Test” is displayed. If a test is active, but the receiver is not in pattern sync,

“No Sync” is displayed. If the receiver is in pattern sync, “In Sync” is

displayed.

Elapsed Time

Displays the time elapsed since a timed test began or, if completed, the total

test time.

Bit Errors

Displays the total number of bit errors detected since the test began or since

error statistics were cleared.

Errored Seconds

Displays the number of asynchronous errored seconds detected since the test

began or since error statistics were last cleared.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 134 135

Pas de commentaire

Verilink WANsuite 5330 (34-00302.F) Product Manual Manuel d'utilisateur Page 118