Verilink WANsuite 5230 (34-00304.F) Product Manual Manuel d'utilisateur télécharger pdf (Page 133)

VT100 Interface 4-17

Gateway IP Address

IP address of the default gateway (router) on the LAN side of the unit.

DHCP Client

If DHCP Client is enabled at power-up, the unit will request its IP, Mask, and

Gateway addresses from a DHCP server located on the LAN side of the unit,

and the unit will use these addresses. If the DHCP request is unsuccessful, the

unit will use the configured addresses shown on this screen.

Client Identifier

Displays a unique identifier for a specific IP address.

Physical Address

Displays unique MAC address.

NOTICE: Always verify that a DHCP server is available on the network before

enabling DHCP Client. If, on power-up, a DHCP server is not found, a

60-second timeout will occur.

NOTICE: If you manually change the IP address, you must “Save and Restart.”

(See Save and Restart on page 4-6.)

Supervisory Configuration Screen

The Supervisory Configuration screen (Figure 4.13) displays the current speed

of the Supervisory port interface along with other parameters as described

below. The Supervisory port supports only asynchronous character formats.

Figure 4.13

Supervisory Config Screen

Speed

Used to change the Supervisory port speed (in bits per second).

Values: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200

Default:19200

Character Size

Selects the number of bits required to make up one asynchronous character.

Values: Five, Six, Seven, Eight

Default: Eight

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 232 233

Pas de commentaire

Verilink WANsuite 5230 (34-00304.F) Product Manual Manuel d'utilisateur Page 133