Verilink WANsuite 7205 (34-00317.B) Product Manual Manuel d'utilisateur télécharger pdf (Page 35)

Web Server Interface 3-5

Figure 3.4

Network 2 Screen

Function (Network 2

Only)

In the “Slaved” function, Network 2 is slaved and receives its timing from the

same source from which Network 1 receives its timing. In the Network

function, Network 2 is an independent network and can only be connected to

Serial 2 in TDM mode.

Values: Slaved, Network

Default: Slaved

NOTICE: The “Function” parameter fundamentally affects the operation of the

unit. Even though this parameter is found only on the Network 2 screen,

its setting affects all three Network ports and the Service table.

Framing

Selects the framing for the Network side of the DSU/CSU.

Values CCS, CAS, Unframed

Default: CCS

Coding

Sets the Network side line coding.

Values: HDB3, AMI

Default: HDB3

Timing

Sets the timing source to synchronize the unit’s internal timing generators. In

all cases, slips are controlled to occur on frame boundaries at the Network

ports when timing synchronization is lost. The options are as follows:

Network 1

“Function” parameter (on the Network 2 screen) in “Slaved” mode − Internal,

Network 1, Network 2, Network 3, Serial 1, Serial 2

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 220 221

Pas de commentaire

Verilink WANsuite 7205 (34-00317.B) Product Manual Manuel d'utilisateur Page 35