Verilink WANsuite 6x30 (34-00315.B) Product Manual Manuel d'utilisateur télécharger pdf (Page 131)

VT100 Interface 4-33

Service Aware

The Service Aware function recognizes IP traffic on the WAN and counts the

number of frames and bytes passed for a specific service based on filters by

VPI/VCI, by IP Address, and by IP Port. Each row of the Service Aware table

represents a specific set of filter parameters known as a “rule.” Each rule is

established through the Rule Config screen, which is accessed by selecting

“Rule Details.”

The Service Aware screen (Figure 4.29) provides a table showing these

filtered packet counts for up to 10 rules. This table indicates which Service

Aware filters are enabled or disabled, and shows the specific VPI/VCI, IP

Address, and IP Port by which the IP traffic is filtered. In addition, this table

shows the Tx Alarm Threshold and the current Tx Alarm status (if enabled)

for each rule.

Figure 4.29

Service Aware Screen

Rule Config Screen

Use the Rule Config screen (Figure 4.30) to establish Service Aware

parameters. To establish a rule, select the desired rule configuration options,

provide the appropriate filter information where required, and press the “Esc”

key.

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 180 181

Pas de commentaire

Verilink WANsuite 6x30 (34-00315.B) Product Manual Manuel d'utilisateur Page 131